The PEAKBAR H2O PRO POD 10ML cartridge is a replacement refillable cartridge specially designed for the H2O PRO POD KIT. Featuring a generous 10 ml tank and an integrated 0.45-ohm Mesh coil, it makes it easy to restore your device's original performance when the previous cartridge reaches the end of its life.

Designed to work equally well at 12W or 23W, this cartridge delivers vaping ranging from a gentler, more economical draw to denser vapor production. It is also compatible with the H2O PRO water chamber system, which gives this kit its hookah-inspired experience.

💧 Large 10 ml refillable cartridge

The H2O PRO CARTRIDGE has a particularly generous tank capacity of 10 ml.

This capacity considerably reduces the frequency of refills throughout the day, particularly when the kit is used at 23W with high vapor production.

The cartridge is sold empty, without e-liquid or nicotineYou can therefore fill it with your choice of e-liquid suited to the coil.

A balanced ratio of around 50/50 PG/VG is particularly suited to the integrated Mesh coil.

💦 Simple and fast side filling

Filling is done directly on the side of the pod.

An opening protected by a silicone stopper provides quick access to the tank for adding your e-liquid.

This system provides:

• Rapid filling
• Easy handling
• Good leak resistance after closing
• Long battery life thanks to the 10 ml capacity
• Use without a proprietary bottle

The cartridge can therefore be refilled several times before being replaced.

🔥 Integrated 0.45Ω Mesh coil

Each H2O PRO POD CARTRIDGE incorporates a coil 0.45-ohm Mesh.

The Mesh structure increases the heating surface in contact with the cotton, promoting even vaporization of the e-liquid.

It delivers:

• Rapid heating
• Dense vapor
• Consistent flavor reproduction
• Excellent responsiveness
• Vaping suited to RDL / airy draws

The coil is sealed directly into the cartridge and cannot be replaced separately.

When the coil reaches the end of its life, simply replace the entire pod.

⚙️ Compatible with 12W and 23W modes

The 0.45Ω coil is designed to work with both power levels offered by the H2O PRO POD KIT.

12W mode

At 12W, the vape is smoother and more economical.

This power reduces e-liquid and battery consumption while maintaining good flavor intensity.

23W mode

At 23W, the coil delivers a more dynamic vape with more vapor.

This setup will particularly suit users seeking a more airy inhalation and a sensation closer to that of an electronic shisha.

💨 Compatible with the H2O PRO water chamber

The H2O PRO POD CARTRIDGE is designed to work with the PEAKBAR kit’s original water chamber system.

The vapor generated by the coil passes through this chamber before inhalation, which modifies the sensation in the mouth and produces cooler, smoother vapor.

The pod is therefore the part dedicated to the e-liquid and vaporization, while the water tank remains a separate, reusable element.

🌀 Airy and generous vapor

With its 0.45Ω coil and power of up to 23W, this pod is primarily designed for an airy vape.

Depending on the H2O PRO airflow setting, it is possible to obtain a more or less open draw and adjust the amount of vapor produced.

This setup will particularly suit users who enjoy:

• RDL
• Dense vapor
• An open draw
• Long inhalations
• A shisha-inspired experience

♻️ Up to approximately 4 refills depending on usage

PEAKBAR and several distributors indicate a lifespan of approximately up to 4 full refills, or up to approximately 40 ml of e-liquid consumed with a single pod.

This duration is naturally an estimate.

It may vary depending on:

• The type of e-liquid
• The VG ratio
• The power used
• The frequency of inhalations
• The duration of the puffs
• How the coil was primed

Using it at 12W will generally put less strain on the coil than constant use at 23W.

⚠️ About “40,000 puffs”

Some commercial presentations indicate up to 40,000 puffs for this pod.

This does not mean 40,000 puffs obtained from a single 10 ml refill.

This estimate corresponds to the total advertised usage duration of the pod over several refills, under specific conditions.

The actual number of puffs depends heavily on the duration of each inhalation and the power used.

💡 Priming a new cartridge

When using it for the first time, it is essential to prime the coil correctly.

To do so:

• Open the side port
• Fill the cartridge with your e-liquid
• Carefully close the cap
• Wait approximately 10 minutes
• Install the cartridge on the H2O PRO
• Ideally, start in 12W mode

This waiting time allows the coil cotton to become fully saturated and prevents the coil from burning prematurely.

🔄 When should you replace the cartridge?

The H2O PRO CARTRIDGE should be replaced when:

• The flavors become noticeably less intense
• Vapor production decreases
• A burnt taste appears
• Vapor production becomes inconsistent
• The pod begins to develop significant leaks

Since the coil is integrated, no coil disassembly is required: simply install a new cartridge.

⚙️ Compatibility

This cartridge is specially designed for:

H2O PRO POD KIT / H2O PRO POD 40K – PEAKBAR

It features:

• A capacity of 10 ml
• A coil 0.45Ω Mesh
• Side filling
• Compatibility with the modes 12W and 23W
• Compatibility with the H2O PRO water chamber

It is sold individually.

🎯 Who is this cartridge for?

The PEAKBAR H2O PRO POD CARTRIDGE is intended for H2O PRO kit users who want to replace their used pod or have an additional cartridge.

It is particularly suitable for:

• For H2O PRO POD KIT users
• For RDL vaping enthusiasts
• For users looking for a high-capacity tank
• For fans of dense vapor
• For people who want to use their own e-liquid
• For users who enjoy the PEAKBAR water chamber system

⭐ PEAKBAR H2O PRO POD – 10 ml with built-in Mesh coil

With its generous 10 ml capacity, built-in 0.45Ω Mesh coil, and compatibility with 12W and 23W modes, the PEAKBAR H2O PRO POD CARTRIDGE makes it easy to extend the use of your kit.

Rechargeable several times and compatible with the H2O PRO water chamber system, it offers a simple, practical solution for restoring an airy, dense vape rich in flavor without replacing the entire device.